710 Twin-Finity
Single-channel mic/line preamp and Hi-Z instrument DI that combines a 12AX7 tube path with a solid-state path and lets you blend continuously between them. It suits home and project studios, and stage use, that want more tonal choice than an interface preamp offers.
- Blendable 12AX7 tube and solid-state preamp paths
- Front Hi-Z instrument input, 2.2M ohm, JFET DI
- Mic, line and Hi-Z inputs; balanced XLR output
- 70 dB+ gain, 48V phantom, -15 dB pad, polarity invert
- 75 Hz low cut and backlit VU metering
- Rack kit included; 100-240VAC internal supply
Снимки
6Обяви
Още няма обяви за този модел
Когато някой продаде 710 Twin-Finity, обявите и историята на продажбите ще се показват тук.
Продай такъвОписание
The 710 Twin-Finity is a single-channel preamp built around two parallel signal paths: a Class-A tube stage running at 310 volts and a transimpedance solid-state stage. The two are phase-aligned, and a blend control moves continuously from fully tube to fully solid-state. Two gain stages let the tone range from clean, wire-with-gain behaviour to heavier saturation.
The front panel carries a Hi-Z instrument input based on a discrete JFET DI stage, which is selected automatically when a jack is plugged in. Controls include 15 dB pad, polarity invert, 48 V phantom power and a 75 Hz low cut filter, with backlit VU meters for output level and drive. Gain reaches more than 70 dB.
On the rear are an XLR mic input, an XLR line input and a balanced XLR line output fed by a monolithic output stage. The unit has a universal internal power supply and a metal chassis, and is supplied with a 19-inch rack kit for rack use, as well as being usable on a desktop.
Видео
Спецификации
- Марка
- Universal Audio
- Модел
- 710 Twin-Finity
- Категория
- Студио › Преампове и аутборд
Inputs
- Microphone input
- Female XLR
- Balanced line input
- Female XLR
- Unbalanced instrument input
- 1/4" jack
- Mic input impedance
- 2K ohms
- Line input impedance
- 10K ohms
- Hi-Z input impedance
- 2.2M ohms
Outputs
- Balanced line output
- Male XLR
- Internal output impedance
- 600 ohms
Audio
- Tube complement
- 12ax7
- Gain range for unit
- -Infinity to 70dBu
- Mic range gain pot
- 10 ~ 60 dBu
- Line range gain pot
- -10 ~ 40 dBu
- Hi-Z range gain pot
- -10 ~ 40 dBu
- Pad
- -15dB
- High pass filter
- 75Hz
- Mic frequency response
- 20Hz to 100kHz +/- 0.2 dBu
- Line frequency response
- 20Hz to 100kHz +/- 0.2 dBu
- Hi-Z frequency response
- 20Hz to 100kHz +/- 0.2 dBu
- Min THD+Noise @ +4dBU
- 0.1% tube, 0.005% solid-state
Power
- Power requirements
- 100-240VAC
- Maximum power consumption
- 160mA @120VAC, 20W
Physical
- Dimensions
- 8.45W x 3.5H x 10.25D
- Weight
- 5.25 lb
In the box
- Rack kit
- 19" rack kit included