DIG V2
Dual digital delay pedal that runs two linked delay lines with three rack-style voicings (ADM, 12 bit and 24/96). It suits guitarists, bassists and keyboard players who want syncable, MIDI-controllable delays in a compact stereo pedalboard unit.
- Two linked delays, 20 ms to 1.6 s each
- ADM, 12 bit and 24/96 delay voicings
- Series, parallel and ping pong routing
- Five subdivisions plus Free Mode for Delay 2
- Full MIDI via EXP/MIDI jack or USB-C, 300 presets
- True or buffered bypass, stereo in/out
Zdjęcia
8Ogłoszenia
Brak jeszcze ogłoszeń tego modelu
Gdy ktoś wystawi DIG V2, ogłoszenia i historia sprzedaży pojawią się tutaj.
Sprzedaj taki samOpis
DIG V2 combines two integrated delay machines in one pedal. Delay 1 acts as the master, with a time range of 20 ms to 1.6 s set by a knob or tap tempo. Delay 2 follows it through five rhythmic subdivisions (triplet, eighth, dotted eighth, dotted quarter and golden ratio), or runs independently in Free Mode over the same 20 ms to 1.6 s range. Three voicings model early 80s adaptive delta modulation, mid 80s 12 bit PCM and a modern 24 bit/96 kHz delay.
The two delays can be routed in series, parallel or ping pong. Other controls include separate Mix knobs, a shared Repeats knob with an optional separate Delay 2 repeats setting, three modulation levels (off, light, deep) and a Tone knob that works as a high cut to the left and a low cut to the right. Holding the TAP footswitch starts circular repeats, which hold the repeats at a steady level until the switch is released.
The input is a JFET preamp with a mono/stereo switch and a line/instrument level option that adds 10 dB of headroom. Bypass can be relay-switched true bypass (the default) or buffered. The EXP/MIDI jack and USB-C port give full MIDI control, MIDI Clock Sync and 300 preset locations. USB-C also handles firmware updates. The pedal needs a 9 V DC supply, which is not included.
Wideo
Specyfikacja
- Marka
- Strymon
- Model
- DIG V2
- Kategoria
- Efekty i kostki
Inputs
- Audio input
- High impedance ultra low-noise discrete Class A JFET TRS stereo input
- Input impedance
- 1M Ohm
- Input mode switch
- Mono (TS) or Stereo (TRS)
- Line level mode
- 10dB of added headroom
- Expression / control input
- TRS expression pedal, MiniSwitch, MultiSwitch Plus or TRS MIDI
Outputs
- Audio outputs
- Low impedance independent TS stereo outputs
- Output impedance
- 100 Ohm
Connectivity
- MIDI
- Via EXP/MIDI jack or USB-C
- USB
- USB-C for MIDI control and firmware updates
- MIDI presets
- 300 preset locations
- MIDI Clock Sync
- Supported, saved per preset
Audio
- Delay time
- 20ms to 1.6s
- Delay voicings
- ADM, 12 bit, 24/96
- Converters
- 24-bit 96kHz A/D and D/A
- Processing
- 520MHz ARM Superscalar processor, 32-bit floating point
- Frequency response
- 20Hz to 20kHz
- Bypass
- Relay true bypass (default) or buffered bypass
Controls
- Footswitches
- Tap Tempo and On/Off
- Routing options
- Series, Parallel, Ping Pong
- Modulation
- Off, light, deep
Power
- Power requirement
- 9V DC center-negative, 300mA minimum
- Power supply
- Not included
Physical
- Dimensions (D x W x H)
- 4.5" (11.43 cm) x 4" (10.16 cm) x 2.4" (6.1 cm)
- Chassis
- Pink aluminum
- Made in
- USA