SPL Crescendo duo
Two-channel microphone preamplifier in a 19-inch rack housing, built on the maker's 120 V internal-rail technology. Aimed at studio recording of acoustic sources, vocals and stereo mic setups where headroom and low noise matter.
- 2 channels, balanced XLR in and out
- Mic gain +18 to +70 dB, output control ±10 dB
- Max output level 32.5 dBu, internal rails ±60 V
- 48 V phantom, polarity, 120 Hz HPF, 20 dB PAD per channel
- Two parallel outputs per channel; 19-inch, 6.1 kg
Ritratti
6Reklami
Għad m’hemmx reklami ta’ dan il-mudell
Meta xi ħadd ibigħ SPL Crescendo duo, ir-reklami u l-istorja tal-bejgħ jidhru hawn.
Biegħ wieħed bħal danDeskrizzjoni
Crescendo duo is a two-channel mic preamp whose audio circuitry runs from internal rails of +/-60 V, using the maker's own SUPRA operational amplifiers. The higher rail voltage gives an input ceiling of +32.5 dBu, which the maker states is 12 dB more headroom than typical +/-15 V designs. This is the v2 revision, which changes the front panel, the housing and the gain steps compared with v1.
Both channels have the same controls: 48 V phantom power, polarity reversal, a 6 dB/octave high-pass filter at 120 Hz, a 20 dB PAD, and a VU-10 switch that lowers the meter reading by 10 dB so high levels stay visible. A stepped Mic Gain switch covers +18 dB to +70 dB, and a switchable output control adds +/-10 dB for matching following AD converters, for a total of 80 dB of gain. Each channel has two parallel outputs, so one signal can feed two devices without an external splitter.
Inputs and outputs are balanced XLR. Power comes from an internal linear supply with a shielded toroidal transformer, switchable between 115 V and 230 V. The front panel is 4 mm black anodized aluminium with milled aluminium knobs, and the housing is powder-coated steel. The unit is made in Niederkrüchten, Germany.
Vidjo
Speċifikazzjonijiet
- Marka
- SPL
- Mudell
- Crescendo duo
- Kategorija
- Studio › Tagħmir ieħor tal-istudio
Inputs
- Channels
- 2
- Input connector
- XLR (balanced)
- Input impedance
- 10 kΩ
- Mic gain range
- +18 dB to +70 dB
- PAD
- 20 dB
- Phantom power
- 48 V
Outputs
- Output connector
- XLR (balanced)
- Outputs per channel
- 2 (parallel)
- Maximum output level
- 32.5 dBu
- Output impedance
- 75 Ω
- Output control range
- +/- 10 dB
- Total gain
- 80 dB
Audio
- High-pass filter
- 6 dB per octave below 120 Hz
- Frequency range (50 dB gain, -3 dB)
- 20 Hz – 100 kHz
- THD + N (10 Hz – 22 kHz, 30 dB gain)
- 0.0036 %
- THD + N (10 Hz – 22 kHz, 70 dB gain)
- 0.32 %
- Noise (A-weighted, 150 Ω, 30 dB gain)
- -89.2 dBu
- Noise (A-weighted, 150 Ω, 70 dB gain)
- -51.7 dBu
- EIN (70 dB gain, 150 Ω)
- -121.7 dBu
- Common mode rejection (1 kHz, 30 dB gain)
- 79 dB
Power
- Audio electronics operating voltage
- +/- 60 V
- Relay and LED operating voltage
- + 12 V
- Mains voltage
- 230 V AC / 50 Hz; 115 V AC / 60 Hz (selectable)
- Fuse for 230 V
- T 0.5 A
- Fuse for 115 V
- T 1 A
- Power consumption
- max. 17.7 VA
Physical
- Dimensions (W x H x D)
- 482 x 88 x 300 mm (19 x 3.46 x 11.8 inch)
- Unit weight
- 6.1 kg (13.45 lbs)
- Shipping weight
- 7.5 kg (16.54 lbs)