RNR1
The RNR1 is an active ribbon microphone with a figure-8 pattern, designed with Rupert Neve. It pairs a 2.5 µm aluminium ribbon with two custom transformers and discrete circuitry, aimed at studio and stage use on vocals, instruments and drums.
- Active ribbon microphone with figure-8 polar pattern
- 2.5 µm hand-tensioned aluminium ribbon
- Two custom transformers designed by Rupert Neve
- 100 Hz low-cut filter
- Requires 48 V phantom power
- Includes custom shockmount, wooden box and metal case
Fotók
7Hirdetések
Ehhez a modellhez még nincs hirdetés
Ha valaki elad egy RNR1 modellt, itt jelennek meg a hirdetések és az eladási előzmények.
Eladok egy ilyetLeírás
The RNR1 is a phantom-powered active ribbon microphone developed with Rupert Neve. Its 2.5 µm hand-tensioned aluminium ribbon sits between two custom transformers with a discrete circuit that keeps the high-frequency response extended, compensating for the roll-off typical of ribbon designs. It has a figure-8 pattern and a 20 Hz to 20 kHz frequency range.
The flat, scalloped matte-black chassis is machined to give the ribbon an acoustically suited fit. A switchable 100 Hz low-cut filter is included, along with gold-plated XLR connectors. The body is designed to sit centred in the supplied custom shockmount, which allows close placement on drums or in a concert hall setup.
The microphone connects through a 3-pin male XLR output and needs 48 V phantom power (P48, IEC 61938). It ships in a wooden box and a metal case with a thread adapter and user manual. Suggested applications include vocals, acoustic and electric guitar, strings, piano, woodwinds, brass, drums, overheads and room.
Videó
Műszaki adatok
- Márka
- sE Electronics
- Modell
- RNR1
- Kategória
- Stúdió › Mikrofonok
Transducer
- Transducer
- Handmade 2.5 µm aluminium ribbon
- Electronics
- Active
- Polar pattern
- Figure 8
Audio
- Frequency range
- 20 Hz - 20 kHz
- Sensitivity
- 25 mV/Pa (-32 dB)
- Max SPL
- 137 dB (0.5% THD at 1 kHz)
- Equivalent noise level
- 17 dB(A)
- Signal-to-noise ratio
- 77 dB
- Low-cut filter
- 100 Hz
- Electrical impedance
- 200 ohms
Connectivity
- Connector
- 3-pin male XLR
- Mating connector
- XLR3F
Power
- Power
- 48 V phantom power (P48 per IEC 61938)
Physical
- Diameter
- 47 mm (1.85 in)
- Length
- 268 mm (10.55 in)
- Weight
- 860 g (30.34 oz)
In the box
- Microphone
- RNR1
- Shockmount
- Custom shockmount
- Cases
- Wooden box and metal case
- Accessories
- Thread adapter
- Documentation
- User manual