PZ-DI
Active direct box for acoustic and orchestral instruments, with a three-position input load selector for magnetic pickups or piezo transducers, a variable low-cut filter and a switchable high-cut filter. Aimed at live players of upright bass, violin, banjo and acoustic guitar.
- Active DI optimized for piezo and orchestral instruments
- Selectable load: 220k ohm, 1 meg ohm or 10 meg ohm
- Variable low-cut filter for resonance and feedback
- Switchable high-cut filter to smooth top end
- Powered by 48V phantom, no batteries
- Part no. R800 3005 00
Ritratti
7Reklami
Għad m’hemmx reklami ta’ dan il-mudell
Meta xi ħadd ibigħ PZ-DI, ir-reklami u l-istorja tal-bejgħ jidhru hawn.
Biegħ wieħed bħal danDeskrizzjoni
The PZ-DI is an active DI that takes a signal from an instrument pickup and delivers it to a mixing console. Its input impedance can be set to 220k ohm, 1 meg ohm or 10 meg ohm, so the same box can suit a magnetic pickup, a typical active instrument or a piezo transducer. The 10 meg ohm setting is intended to reduce the harsh, peaky tone a piezo can produce into a lower-impedance input.
Tone is shaped with two filters. A fully variable low-cut filter rolls off low frequencies to control stage resonance and feedback, and can be set lower for acoustic bass or higher for violin and banjo. A switchable high-cut filter softens the top end, which helps with acoustic guitars that have a battery-powered preamp.
The unit is powered by 48V phantom power, so no batteries are needed. It is intended for live stage use and also for recording or reamping a bass with the 220k ohm setting. Radial offers the J-Rak 4 rack adapter for mounting four of its DI boxes in a 19-inch rack.
Vidjo
Speċifikazzjonijiet
- Marka
- Radial Engineering
- Mudell
- PZ-DI
- Kategorija
- Ħoss ħaj › Ħoss ħaj ieħor
Inputs
- Input impedance settings
- 220k ohm / 1 meg ohm / 10 meg ohm
- Load selector
- 3-position variable load switch
- Intended pickups
- Piezo transducers and magnetic pickups
Audio
- Type
- Active direct box
- Low-cut filter
- Fully variable
- High-cut filter
- Switchable
- Piezo setting
- 10 meg ohm
- Magnetic pickup setting
- 220k ohm
- Standard active DI setting
- 1 meg ohm
Power
- Power source
- 48V phantom power
- Batteries
- Not required
Physical
- Part number
- R800 3005 00
- Rack mounting
- J-Rak 4 4-space rack adapter (optional, holds four Radial DIs in 19" rack)
Software
- Resources
- Owners manual, Smart Sheet, photos