Pick it MM EVO
Moving-magnet phono cartridge made by Ortofon and voiced by Pro-Ject, with an elliptical stylus and 7 mV output. It suits turntables with low to medium mass tonearms and uses the standard half-inch mounting.
- Moving-magnet cartridge made by Ortofon, voiced by Pro-Ject
- Elliptical stylus, r/R 8/18 µm
- 7 mV output voltage
- Recommended tracking force 1.8 g (range 1.6–2 g)
- Suits low to medium mass tonearms
- Half-inch mounting with threaded holes; stylus sold separately
Fotók
8Hirdetések
Ehhez a modellhez még nincs hirdetés
Ha valaki elad egy Pick it MM EVO modellt, itt jelennek meg a hirdetések és az eladási előzmények.
Eladok egy ilyetLeírás
The Pick it MM EVO is a moving-magnet cartridge built by Ortofon and tuned by the Pro-Ject design team. It carries an elliptical stylus on a robust cantilever derived from those used in DJ cartridges, so it is intended to be durable as well as detailed.
Its motor uses Ortofon split pole pins, which give a flat frequency response said to compare well with moving-coil cartridges. Other listed characteristics include low distortion, a wide dynamic range and suitability for low to medium tonearm masses. Output is 7 mV, with a recommended tracking force of 1.8 g.
The body follows the half-inch mounting standard and has threaded holes, so it can be fitted without nuts. The stylus is available separately as a replacement. The cartridge is made in Europe and is loaded with 47 kΩ and 150–300 pF.
Videó
Műszaki adatok
- Márka
- Pro-Ject
- Modell
- Pick it MM EVO
- Kategória
- DJ-felszerelés › Hangszedők és tűk
Cartridge
- Cartridge principle
- MM (Moving-Magnet)
- Stylus type
- elliptical
- Stylus tip radius
- r/R 8/18 μm
- Mounting standard
- 1/2 inch
- Origin
- Made in Europe
Audio
- Output voltage
- 7 mV
- Channel separation at 1 kHz
- 22 dB
- Trackability (315 Hz, lateral)
- 70 µm
- Frequency response
- 20 - 20 000 Hz (+3 /-1 dB)
Tracking and loading
- Tracking force, range
- 1,6 - 2 g (mN)
- Recommended tracking force
- 1,8 g (mN)
- Tracking angle
- 20°
- Recommended load resistance
- 47 kΩ
- Recommended load capacitance
- 150 - 300 pF
Physical
- Height stylus tip to top mounting surface
- 18 mm
- Weight
- 7.2 g