TLM 170 R
Large-diaphragm studio condenser microphone with five polar patterns, selectable on the mic or remotely from the optional N248 power supply. It suits vocals, speech, orchestral and general studio recording.
- Five polar patterns plus remote selection via N248 PSU
- Max SPL 154 dB with –10 dB preattenuation
- Self-noise 14 dB-A, dynamic range 130 dB
- Switchable 100 Hz low cut
- K89 dual-diaphragm large capsule
- Transformerless fet 100 output stage
Fotos
5Anúncios
Ainda não há anúncios deste modelo
Quando alguém vender um TLM 170 R, os anúncios e o histórico de vendas aparecem aqui.
Vender um igualDescrição
The TLM 170 R is a pressure-gradient condenser microphone built around a dual-diaphragm K89 capsule. A rotary switch selects omni, wide cardioid, cardioid, hypercardioid or figure-8. A sixth switch position hands pattern selection over to the optional N248 power supply.
A –10 dB preattenuation switch raises the maximum SPL from 144 dB to 154 dB. A second switch applies a 100 Hz low cut. The transformerless fet 100 output stage and low self-noise of 14 dB-A allow it to handle both quiet and very loud sources. Its dynamic range is 130 dB.
The microphone runs on 48 V phantom power and connects through a 3-pin XLR. Remote pattern control uses voltage sensing: the phantom voltage is varied within the P48 tolerance, so no special cable is needed and other microphones on the same supply are unaffected. It is available in nickel or black, singly or as a stereo set.
Vídeo
Especificações
- Marca
- Neumann
- Modelo
- TLM 170 R
- Categoria
- Estúdio › Microfones
Audio
- Operating principle
- Pressure gradient transducer
- Polar patterns
- Omnidirectional, wide angle cardioid, cardioid, hypercardioid, figure-8
- Frequency range
- 20 Hz ... 20 kHz
- Sensitivity at 1 kHz into 1 kohm
- 8 mV/Pa ± 1 dB
- Equivalent noise level, CCIR
- 26 dB
- Equivalent noise level, A-weighted
- 14 dB-A
- Max. SPL for THD 0.5%
- 144 dB
- Max. SPL for THD 0.5% with preattenuation
- 154 dB
- Signal-to-noise ratio, CCIR (re. 94 dB SPL)
- 68 dB
- Signal-to-noise ratio, A-weighted (re. 94 dB SPL)
- 80 dB
- Dynamic range
- 130 dB
- Switches
- –10 dB preattenuation, 100 Hz low cut
Outputs
- Rated impedance
- 50 ohms
- Rated load impedance
- 1 kohms
- Maximum output voltage
- 10 dBu
- Matching connector
- XLR 3 F
Power
- Supply voltage (P48, IEC 61938)
- 48 V ± 4 V
- Current consumption (P48, IEC 61938)
- 3 mA
Physical
- Weight
- 625 g
- Diameter
- 60 mm
- Length
- 152 mm
- Colour variants
- Nickel (007165), black mt (007166)
In the box
- TLM 170 R / R mt
- Microphone in wooden box
- Stereo Set contents
- 2 x microphone, 2 x EA 170 shock mount, aluminium case