M 49 V
Reissue of the 1950s M 49 studio tube microphone with a continuously variable polar pattern that is set remotely from the power supply. Aimed at studios recording vocals and a wide range of instruments.
- Continuously variable polar pattern, remote controlled
- Reissue of the M 49 c circuit with a lower-noise subminiature tube
- K 49 capsule and classic tube circuit with output transformer
- NM V linear power supply adapts to mains voltage
- RF-proof 7-pin connector adopted from the M 249
- Handmade and hand soldered in Germany
Fotografije
8Oglasi
Oglasov za ta model še ni
Ko bo kdo prodajal M 49 V, se bodo tu prikazali oglasi in zgodovina prodaj.
Prodaj takšnegaOpis
The M 49 V is a large-format tube condenser microphone based on the last historical revision, the M 49 c. It uses the same circuit and the K 49 capsule, but replaces the no-longer-available Telefunken AC701k with a lower-noise subminiature tube. The polar pattern can be varied continuously from omnidirectional through cardioid to figure-8, and is controlled remotely from the power supply unit.
The set includes the NM V pattern control unit, a linear power supply that supplies the correct heater voltage for the M 49 V and for historical M 49 microphones, and adapts to the local mains voltage. Also supplied are a yoke mount with mechanical decoupling and a cable holder, a KC 5 cable, an MZ 49 A shock mount and an aluminium case. The microphone is handmade in Germany.
The microphone connects through an RF-proof 7-pin connector taken from the M 249 broadcast version, via the KC 5 cable to the NM V, which has an XLR 3 F output. Two internal switches, set only by Neumann Service, allow a 12 Hz high-pass or a fixed cardioid pattern, and can be ordered made to order.
Video
Specifikacije
- Znamka
- Neumann
- Model
- M 49 V
- Kategorija
- Studio › Mikrofoni
Audio
- Acoustical operating principle
- Pressure gradient transducer
- Directional pattern
- Variable (omnidirectional...cardioid...figure-8)
- Frequency range
- 40 Hz...16 kHz
- Sensitivity at 1 kHz into 1 kohm
- 6.5/8/10 mV/Pa ± 1 dB (-43.5/-42/-40 dBV)
- Equivalent noise level, CCIR
- 32/30/30 dB
- Equivalent noise level, A-weighted
- 21/20/19 dB-A
- Maximum SPL for THD 0.5%
- 125 dB (cardioid)
- Signal-to-noise ratio, CCIR (re. 94 dB SPL)
- 62/64/64 dB
- Signal-to-noise ratio, A-weighted (re. 94 dB SPL)
- 73/74/75 dB
- High-pass filter (standard)
- 1st order, 30 Hz
Outputs
- Rated impedance
- 200 ohms
- Rated load impedance
- 1000 ohms
- Maximum output voltage
- 300 mV ~ - 8 dBu
Connectivity
- Microphone connector
- KC 5 cable (7-pin)
- Power supply unit output connector
- XLR 3 F
Power
- Power supply
- NM V
Physical
- Weight
- 800 g
- Diameter
- 80 mm
- Length
- 163 mm
- Color
- Nickel
In the box
- Microphone
- M 49 V tube microphone
- Pattern control unit
- NM V
- Cable
- KC 5
- Shock mount
- MZ 49 A
- Case
- Aluminium case
- Documentation
- Quick Guide, Safety Guide