
PLASMA Pedal
A guitar distortion pedal that clips the signal by passing it through a xenon-filled gas discharge tube, producing an audible electrical arc. It has Voltage, Blend and a two-band EQ, and suits guitarists after extreme fuzz and gated tones.
- Clips the signal with a xenon-filled gas discharge tube
- Signal is amplified up to 3500 V to create the arc
- Voltage knob sets the threshold, from sustain to gated
- Blend knob mixes in the clean signal or other effects
- Two-band EQ with a switch for plasma-only or plasma plus clean
- Power supply not included: 9V DC, centre-negative
Fotók
8Hirdetések
Ehhez a modellhez még nincs hirdetés
Ha valaki elad egy PLASMA Pedal modellt, itt jelennek meg a hirdetések és az eladási előzmények.
Eladok egy ilyetLeírás
The Plasma Pedal replaces the usual diode, transistor or valve clipping stage with a different method. The input signal is stepped up to as much as 3500 volts and drives an electrical arc between two electrodes in a xenon-filled gas discharge tube. The arc is visible as a blue light on the front panel. An analog rectifier circuit then converts the discharges back to audio level.
The Voltage knob sets the signal threshold needed to make a connection in the tube, which moves the sound between open, sustaining distortion and chopped, sputtery gated tones. A Blend knob mixes the plasma distortion with the clean signal or with other effects and gain stages. An on-board EQ offers low and high boosts and cuts, and a toggle switch applies it either to the plasma signal only or to both the plasma and clean signals.
The pedal has a 1/4" unbalanced input and output plus a DC input for a standard centre-negative 9V supply. No power supply is included, and the unit needs at least 250 mA.
Videó
Műszaki adatok
- Márka
- Gamechanger Audio
- Modell
- PLASMA Pedal
- Kategória
- Effektek és pedálok
Inputs
- Input type
- 1/4" Unbalanced TS
- Input impedance
- 1MΩ
- Max input level
- 7Vpp (+10dBu)
Outputs
- Output type
- 1/4" Unbalanced TS
- Output impedance
- 100Ω
- Max output level
- 7Vpp (+10dBu)
Audio
- Frequency response
- 20Hz to 22kHz
- EQ low frequency boost/cut
- ± 9dB, 600Hz corner freq.
- EQ high frequency boost/cut
- ± 10dB, 1.5kHz corner freq.
- Maximum signal voltage in tube
- Up to 3500 V
Connectivity
- Connectors
- IN, OUT, DC input
- Indicator
- White check indicator LED
Power
- Power connector
- Center negative, 2.1 x 5.5 mm barrel plug (the standard 9V)
- Power requirements
- 300mA, 9VDC
- Peak power consumption
- 2.7 W
- Mean power consumption
- 1 W
- Power consumption during stand-by
- 0.025 W
Physical
- Dimensions
- 148 mm * 96 mm * 70 mm
- Weight
- 840 g / 1.8 lbs
In the box
- Power supply
- Not included