The Wave Transformer
The Wave Transformer is a 20HP Eurorack analog voltage-controlled oscillator with a vintage voice and more than 8 octaves of pitch tracking. It offers seven simultaneous waveform outputs, including a Complex output with a waveshaping circuit, for modular synth users who want evolving, harmonically rich tones.
- 20HP analog Eurorack voltage-controlled oscillator
- Over 8 octaves of accurate pitch tracking
- 7 simultaneous outputs including Complex
- Hard sync, soft sync, linear FM and exponential FM
- Shape Insert jack for external signals
- 90 mA max from +12V rail; skiff friendly
Fotografije
8Oglasi
Oglasov za ta model še ni
Ko bo kdo prodajal The Wave Transformer, se bodo tu prikazali oglasi in zgodovina prodaj.
Prodaj takšnegaOpis
The Wave Transformer is an analog, voltage-controlled oscillator with over 8 octaves of accurate pitch tracking. It provides seven wave outputs at the same time: sine, triangle, saw, rectangle, sub pulse, sub square and a Complex output. The Transform control sweeps the Complex output from a triangle wave into a dense, harmonically complicated waveform, using an asymmetrical multi-differential circuit.
The core can be shaped further with hard sync, soft sync, linear FM and exponential FM. The source waveform can be muted so the circuit works as a harmonic gate or VCA. A Shape Insert jack lets external oscillators or modular-level audio signals pass through the Transform circuit. Panel controls cover coarse tune (about 7 octaves), fine tune, a micro tune of about 25 cents, pulse width, sub source, sub octave and complex source switching.
CV inputs are provided for V/Octave, pulse width, transform and micro tune, alongside the sync, FM and Shape Insert jacks. The module is powered through a standard 10-pin Eurorack connector, uses only the +12V rail and is shallow enough for skiff cases.
Video
Specifikacije
- Znamka
- EarthQuaker Devices
- Model
- The Wave Transformer
- Kategorija
- Sintesajzerji in klaviature › Modularni (Eurorack)
Controls
- Sub Source
- Internal oscillator or Shape Insert signal
- Sub Octave
- 1 octave down, 2 octaves down or muted
- Complex Source
- Mute / unmute source wave
- Tune
- Coarse, approx. 7 octaves
- Fine Tune
- A little more than 1 octave
- µTune
- Approx. 25 cents
- Pulse Width
- 0%–100%
- Transform
- Morphs Complex output from triangle to complex waveform
Inputs
- Hard Sync
- +/-5 V
- Soft Sync
- +/-5 V
- V/Octave
- Traditional volt/octave CV
- Shape Insert
- +/-5 V
- Lin FM
- +/-5 V
- Expo FM
- +/-10 V
- Pulse Width CV
- +/-5 V
- Transform CV
- +/-5 V
- µTune CV
- +/-10 V
Outputs
- Sine
- +/-5 V
- Triangle
- +/-5 V
- Saw
- +/-5 V
- Complex
- Up to +/-10 V
- Rectangle
- +/-5 V
- Sub Pulse
- +/-5 V, 25% duty cycle, 1 octave down
- Sub Square
- +/-5 V, 1 or 2 octaves down
Power
- Current draw
- 90 mA max from +12V rail, 0 mA from -12V and +5V
- Power connector
- Standard 10-pin Eurorack, negative pins marked
Physical
- Width
- 20HP
- Max depth
- 1 inch (25.4 mm)
- Skiff friendly
- Protrudes less than 1 inch (25.4 mm) behind panel
Other
- Warranty
- Limited lifetime warranty