Blumes
EarthQuaker Devices Már nem gyártják

Blumes

All-analog bass overdrive with three clipping modes, derived from the Plumes screamer circuit with double the gain and extended low-end response. Aimed at bass players, and it also suits low-tuned guitar.

  • All-analog tri-mode soft clipping bass overdrive
  • Double the gain and deeper bass response than Plumes
  • 3-way toggle: LED, no clipping, silicon diode
  • Gain, Tone and Level controls
  • Relay-based true bypass with latching and momentary modes
  • 9 V DC, 2.1 mm negative center, 25 mA
Eladok egy ilyet

Fotók

8

Hirdetések

Ehhez a modellhez még nincs hirdetés

Ha valaki elad egy Blumes modellt, itt jelennek meg a hirdetések és az eladási előzmények.

Eladok egy ilyet

Leírás

Blumes is an analog bass overdrive built on the screamer-style circuit used in the maker's Plumes pedal. The circuit is modified to give twice the gain and a deeper bass response, so low frequencies are kept intact. Internal bipolar power supplies additional headroom and dynamics.

Gain sets the amount of drive, Tone sweeps from more bass to more treble, and Level sets output volume. A 3-way toggle selects the clipping mode: symmetrical LED clipping for the crunchiest, most open sound; no clipping, which is straight op-amp drive usable as a clean boost at lower Gain settings; and asymmetrical silicon diode clipping, which is warmer, more compressed and lower in output.

Switching is relay-based true bypass using Flexi-Switch, which supports both latching and momentary operation. The pedal runs from a standard 9 V DC supply with a 2.1 mm negative-center barrel connector, and the relay needs power to pass signal.

Videó

Műszaki adatok

Márka
EarthQuaker Devices
Modell
Blumes
Kategória
Effektek és pedálok

Controls

Knobs
Gain, Tone, Level
Toggle
3-way clipping mode switch
Mode 1
Symmetrical LED clipping
Mode 2
No clipping (op-amp drive)
Mode 3
Asymmetrical silicon diode clipping

Audio

Circuit
All-analog
Effect type
Bass overdrive
Input impedance
10 MΩ
Output impedance
100 Ω
Internal power
Internal bipolar power

Switching

Bypass type
Relay-based true bypass
Switching technology
Flexi-Switch (latching and momentary)

Power

Supply voltage
9 V DC
Connector
2.1 mm barrel, negative center
Current draw
25 mA

Physical

Dimensions
4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
Artwork
Jamie Stillman

Support

Warranty
Limited lifetime warranty
Documentation
Operation manual available for download

Dokumentumok

PDF Használati útmutatóPDF · a gyártótól

Adatok: earthquakerdevices.com; fotók: EarthQuaker Devices product page · frissítve: 2026-10-13 · Hibát találtál? Írj nekünk