Arrows
EarthQuaker Devices Descontinuado

Arrows

Compact all-discrete analog pre-amp booster pedal for guitar, bass and keys with a single level control. It adds midrange push and tighter lows to drive pedals or brightens a signal on its own. No longer in production.

  • All-discrete analog pre-amp booster
  • Single Level control boosts or cuts the signal
  • True bypass with relay-based switching
  • 9 V DC, 2.1 mm negative center, 8 mA draw
  • Handmade in Akron, Ohio
  • No longer in production
Vender um igual

Fotos

7

Anúncios

Ainda não há anúncios deste modelo

Quando alguém vender um Arrows, os anúncios e o histórico de vendas aparecem aqui.

Vender um igual

Descrição

The Arrows is a single-knob boost built from discrete components. The Level control either boosts or cuts the signal, so it can add an extra gain stage in front of overdrive and fuzz pedals, tighten up bass-heavy fuzzes, brighten neck pickups, or lift a clean signal by itself. The voicing emphasises the midrange, firms up the low end and opens up the top end.

The circuit is fully analog and uses true bypass, switched by an electronic relay. Because of the relay, audio does not pass when the pedal is unpowered. Input impedance is 10 MΩ and output impedance is below 10 kΩ. Current draw is 8 mA.

The pedal runs from a standard 9 V DC supply with a 2.1 mm negative-center barrel connector and should not be run at higher voltages. Pedal-specific, isolated power supplies are recommended to avoid noise. It is handmade in Akron, Ohio, is covered by a limited lifetime warranty, and an operation manual is available for download.

Vídeo

Especificações

Marca
EarthQuaker Devices
Modelo
Arrows
Categoria
Efeitos e pedais

Controls

Controls
Level
Level range
Clockwise is loud, counterclockwise is quiet
Function
Pre-amp booster

Audio

Circuit
All-discrete, all analog
Input impedance
10 MΩ
Output impedance
<10 kΩ
Bypass
True bypass

Switching

Switching type
Electronic relay-based
Unpowered behavior
Audio will not pass without power

Power

Supply voltage
9 V DC
Connector
2.1 mm barrel, negative center
Current draw
8 mA
Maximum voltage
Do not run at higher voltages than 9 V

Physical

Dimensions
4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
Construction
Handmade in Akron, Ohio

Software

Operation manual
Downloadable
Warranty
Limited lifetime warranty

Documentos

PDF Manual de utilizadorPDF · do fabricante

Dados: earthquakerdevices.com; fotografias: EarthQuaker Devices product page · atualizado em 2026-10-13 · Encontraste um erro? Escreve-nos