Acapulco Gold

Acapulco Gold

A compact one-knob distortion pedal that aims to reproduce the sound of a cranked vintage Model T amp. It suits guitarists who want power-amp style crunch and overdrive controlled mostly from the guitar's own volume and tone knobs.

  • One-knob output level control with footswitch
  • Modeled on a cranked vintage Model T amp
  • True bypass, relay-based switching
  • 9 V DC, 2.1 mm negative center, 18 mA
  • Audio does not pass without power
  • Limited lifetime warranty
Sprzedaj taki sam

Zdjęcia

5

Ogłoszenia

Brak jeszcze ogłoszeń tego modelu

Gdy ktoś wystawi Acapulco Gold, ogłoszenia i historia sprzedaży pojawią się tutaj.

Sprzedaj taki sam

Opis

The Acapulco Gold is a distortion pedal with a deliberately minimal layout: a footswitch for on/off and one large knob that sets output level. There are no gain or tone controls, so the amount of drive and the tonal colour are shaped from the guitar. Turning the guitar's volume down reduces gain, and rolling back its tone control gives a darker rhythm sound.

With the guitar volume fully up, the pedal gives a loud, wide-open amp-style roar. Backing the guitar off slightly gives a rough overdrive, and at minimum volume the sound is hazy and spanky. On a guitar with separate volume and tone controls per pickup and a three-way switch, the pedal can be used as a three-channel setup. The output level can be very high, so the maker advises caution.

The pedal is true bypass with electronic relay-based switching, so no audio passes without power. It runs from a 9 V DC supply through a 2.1 mm negative-center barrel connector and draws 18 mA. The maker recommends isolated, pedal-specific power supplies and warns against higher voltages. It is built by hand in Akron, Ohio.

Wideo

Specyfikacja

Marka
EarthQuaker Devices
Model
Acapulco Gold
Kategoria
Efekty i kostki

Controls

Controls
Output level (big knob)
Footswitch
On/off
Effect type
Power amp distortion

Audio

Input impedance
50 kΩ
Output impedance
<10 kΩ
Switching
True bypass, electronic relay-based switching
Bypass without power
Audio will not pass without power

Power

Power supply
9 V DC
Power connector
2.1 mm barrel, negative center
Current draw
18 mA
Voltage warning
Do not run at higher voltages

Physical

Dimensions
4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
Made in
Akron, Ohio, United States

Software

Operation manual
Downloadable from the maker

Warranty

Warranty
Limited lifetime warranty

Dokumenty

PDF Instrukcja obsługiPDF · od producenta

Dane: earthquakerdevices.com; zdjęcia: EarthQuaker Devices product page · zaktualizowano 2026-10-13 · Widzisz błąd? Napisz do nas