Bastl Instruments Quattro Figaro
Quattro Figaro is a 10 HP Eurorack module with four voltage-controlled amplifiers, each with its own CV inverter, plus mixed outputs. Its jack-switch routing between channel pairs makes it a tool for panning, crossfading and voltage-controlled mixing. It has been discontinued.
- 4-channel VCA with gain knob and CV attenuator per channel
- CV inverter output on every channel
- Mixed outputs: -(A+C), -(B+D), A+B+C+D, -(A+B+C+D)
- Jack-switch routing of A to B and C to D for panning/crossfading
- 10 HP, 35 mm deep
Fotografije
6Oglasi
Oglasov za ta model še ni
Ko bo kdo prodajal Bastl Instruments Quattro Figaro, se bodo tu prikazali oglasi in zgodovina prodaj.
Prodaj takšnegaOpis
Quattro Figaro has four VCA channels, A to D. Each channel has a gain knob, a CV input with an attenuator knob, an inverted CV output, a signal input and a signal output. Gain follows the control voltage linearly. Control voltages above 6 V are compressed non-linearly, which comes from the VCA chip, and maximum gain is a little above 2.
Channels A and B, and C and D, are paired through jack switches. With nothing plugged into the signal input of channel B, the signal and the inverted CV from channel A feed channel B automatically, which gives a quick panning or crossfading setup. Plugging a cable into a jack breaks that connection, so every channel can also be used on its own.
Four mixed outputs allow use as a voltage-controlled mixer or stereo panning mixer: -(A+C), -(B+D), A+B+C+D and -(A+B+C+D). The module is 35 mm deep and runs from a 16-pin power connector with PTC fuse and diode protection. It is handmade in Brno, Czech Republic, with an aluminium or oak wood front panel, and a DIY kit (PCB and panel only) was also offered.
Video
Specifikacije
- Znamka
- Bastl Instruments
- Model
- Quattro Figaro
- Kategorija
- Sintesajzerji in klaviature › Modularni (Eurorack)
Inputs
- VCA channels
- 4 (A, B, C, D)
- Signal inputs
- 1 per channel
- CV inputs
- 1 per channel, with attenuator knob
Outputs
- Signal outputs
- 1 per channel
- Inverted CV outputs
- 1 per channel
- Mixed outputs
- -(A+C), -(B+D), A+B+C+D, -(A+B+C+D)
Audio
- Gain control
- Linear to control voltage
- CV compression
- Non-linear above 6 V
- Maximum gain
- A little above 2
- Controls
- Gain knob and CV attenuator knob per channel
Connectivity
- Internal routing
- A to B and C to D via jack switches (signal and inverted CV)
- Power connector
- 16-pin, PTC fuse and diode protected
Power
- Current +12 V
- < 40 mA
- Current -12 V
- < 35 mA
Physical
- Width
- 10 HP
- Depth
- 35 mm
- Front panel
- Aluminium or oak wood
- Made in
- Brno, Czech Republic (handmade)
- Format
- Eurorack
Software
- Documentation
- PDF user manual